NeonRyder
04-05-2010, 04:12 PM
Well I was spooling in the cable on my winch recently, after 30 seconds or so the motor would slow down to a stop and then reverse. The motor got pretty hot during this process like 200 F.
So yesterday I decide to troubleshoot it. When I check it out with my meter i have power to all three wires on the winch motor during power out and power in. The warn book lists them as A, F1 and F2.
To me this means I have a bad solenoid pack, correct? Any advice on how to test further?
So yesterday I decide to troubleshoot it. When I check it out with my meter i have power to all three wires on the winch motor during power out and power in. The warn book lists them as A, F1 and F2.
To me this means I have a bad solenoid pack, correct? Any advice on how to test further?