I'm sure someone knows how to do this...
So I put a 2" PVC snorkel on my 1999 500.
http://photos-b.ak.fbcdn.net/photos-ak-snc...993521_1767.jpg
The motor runs fine until the higher RPMs near WOT when it bogs down.
The motor also has some white exhaust smoke now and then. No overheating issue since I moved the radiator and fan. New spark plug and clean carb.
I ordered a Dynojet stage 1 jet kit.
Today I put in the Dynojet needle and put it on the 2nd groove for less then 5000ft since I don't ride anything higher than 3000 ft.
The main jet that came out had 145 on it. I put in the dynojet 134 and the motor bogged down much sooner. Barely half throttle. I wasn't sure if the numbers matched up with the stock one so I tried what dynojet recommended to start with. I would say I went in the wrong direction and gave it too little fuel. I guess I need a larger jet than stock.
If the stock jet and Dynojet numbers are equivalent then I'm going to need larger jets than what the kit has since it only goes up to 142.
What size should I try and where can I get larger, accurately sized jets if I need them?
Should I be changing the jet that is in the top of the carb (pilot jet?)?
Thanks for any advice.