So I got a big, but low margin, fab job in for a bunch of cut 6101 bars for bus bar.
Usually would just have them saw on the cold saw at the supplier, well this job has such a low margin that I have to do it.

So I bought a power hacksaw at a auction the other day, a Robertson No4 from looking at it around 1917.
I need to replace the leather hydraulic seals on the blade lift, and the coolant pump has been missing for who knows
how many years. But it runs like a champ. I need to make a stand for it way too short, it was probably went on a bench of some kind.

Pictures in a minute.