I recently installed a new trac bar and PSC hydro assist. After that my ESP/BAS is kicking in on turns engaging the front brakes. My steering wheel was a little off after installing all the new stuff but is straight now after adjusting the draglink. How can I check to see what else would be causing this? 07 JK, jk rubicon axles, 37s.
I have a code p1593 too
Sorry I'm a noob to the JK's...but what is ESP/BAS?
(thank god I have a tj!)
"You can't polish a turd but you can roll it in glitter"
Well I just googled that code. Speed Control Switch half stuck. Says speed sensor bad, harness may have an open in it, or bad connection
97 XJ Clayton Longarms 35s locked etc.
94 YJ MTO
98 5.9 ZJ Limited alllll original
02 Cummins 6spd HO Studs, Sticks, Box, Pump...
I believe there is a way to relearn the steering wheel position sensor with a scanner. I will double check at work tomorrow. The early JKs seem to have a lot more trouble with this than later ones.
That what the internet says, something about recalibrating the steering angle sensor with a super fancy scanner. Let me know if you have the capability to do that.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote